Operating instructions wet waste treatment unit, Model AZP 80, AZ / AP 80
Datei:BA_AZP80_AZ_AP_9633432_EN_2005-10.docx
9633432
23/36
W e reserv e the right to c hange ex ec ution and constr uction!
MEIKO Maschinenbau GmbH & Co. KG, Englerstr. 3, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1121
Garbage can now be given into the unit. The following kinds of waste can be grinded:
Organic material
•
Food residues from the dining room
•
Food waste
Inorganic material
•
Plastic material, such as Polystyrolene, Styropore
•
Disposable dishes and plastic cutlery
•
Yoghourt cup
The unit may not be fed with the following items
•
Metal pieces
•
Glass/porcelaine and chinaware
•
Massive bones
•
Large plastic foils (bags)
In order to ensure a smooth functioning the following fundamental rules should be
observed:
Do not put too large quantities of waste into the feeding chute resp. flushing trough.
Otherwise, the flushing effect towards the grinder is reduced considerably and the
rotational flow in the grinding unit is interrupted. Thus the throughput is reduced.
If possible, the waste should not be sorted before being fed into the unit but should be
mixed, f.ex. food residues with napkins and drinking cups. Hollow-ware such as plastic
containers should only be fed in open condition. Floating parts also reduce the
throughput.
Do not put in oil and grease.
Some garbage can cause increased foam formation. This can be avoided by adding of
other waste or a foam absorbing product. The water level is controlled by an adjustable
stand pipe overflow in the solid parts separator. Adjustment works are made by our
technician when setting the machine in operation.
11
Cleaning
11.1 Safety instructions for cleaning
Machine, electrical components, switch cupboards and other electrical components may
not be sprayed with a water hose or high-pressure cleaner.
11.2 Cleaning after operation
It is recommended that you maintain the machine in good condition not only for reasons of
hygiene but also to keep your dish-washing machine in full working order and to be able to
recognise damage more easily. Observe the following points after operation.
Cleaning of the food waste treatment machine:
1. Open lid, cleaning door and tank covers
2. Clean the solid parts separator with a water hose, possibly with warm water.
When lifting the overflow sheet the water with the garbage residues can be
flushed into the tank.
3. If necessary, remove perforated cylinder and screw and separate them. Both
items can now easily be cleaned on a floor grid or anything else.
4. Rinse the feeding chute with direction to the tank.
5. Rinse tank and grinder.
6. Waste residues, metal pieces etc. can now be removed from the tank by taking
out the two floor sieve baskets.
7. Empty out and clean the bottom screen box.
8. Clean electrodes for the water level control.
ATTENTION!
