Operating instructions wet waste treatment unit, Model AZP 80, AZ / AP 80
Datei:BA_AZP80_AZ_AP_9633432_EN_2005-10.docx
9633432
17/36
W e reserv e the right to c hange ex ec ution and constr uction!
MEIKO Maschinenbau GmbH & Co. KG, Englerstr. 3, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1121
7.3
Installation and assembly
MEIKO has prepared an assembly diagram showing the machine dimensions and the
connected loads in detail.
Assembly is completed by reference to the assembly diagram and, in general, by following
the instructions of a trained MEIKO engineer..
The installation must
o n l y
be connected by suitably qualified personnel.
We accept no liability for connections carried out by unqualified personnel.
After unpacking, position the appliance as indicated in the assembly diagram and as the
dimensions allows.
The appliance must be level and straight when erected.
7.4
Instructions for the disposal of the packaging material
•
The four-sided wooden frame consists of untreated, raw pine / spruce.
•
The plastic sheeting (PE sheeting) may be recycled.
•
The cardboard packaging material used to protect the edges can also be
recycled.
•
The steel tensioning strap made of strip steel may be recycled with the steel
scrap.
•
The plastic tensioning strap of plastic (PP) can be recycled.
7.5
Electrical connection
Work on the electrical part of the machine may only be undertaken by specialist
personnel.
The wiring diagram is located in the switch cabinet.
This wiring diagram is part of the
machine and therefore must not be removed.
The manufacturer’s
plate with the
connected electrical
loads is located behind
the inspection door.
ATTENTION!
ATTENTION!
