Operating instructions wet waste treatment unit, Model AZP 80, AZ / AP 80
Datei:BA_AZP80_AZ_AP_9633432_EN_2005-10.docx
9633432
16/36
W e reserv e the right to c hange ex ec ution and constr uction!
MEIKO Maschinenbau GmbH & Co. KG, Englerstr. 3, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1121
The forks of the pallet trucks are lowered when the desired position of the appliance is
reached (but must remain under the bearers). The machine is standing on the wooden
bearers of the packing. There is no load on the foot cleats.
All the screws and bolts of the packing are now removed.
e.g. Remove these and other screws and bolts.
When all the fasteners on the transport packing have been removed, the machine is
carefully lowered from the wooden bearers.
You must take great care to ensure that the appliance is not jolted when it is
lowered
otherwise the foot cleats could be damaged beyond repair.
If it is necessary to move the appliance along a wall, the appliance can be pushed along
the wall on its cleats for a limited distance.
(Be careful of gratings in the floor and changes in height.).
When the appliance is finally positioned, you must
ensure that all the cleats carry approximately the same
weight.
You can check the loading by means of the force needed
to turn the cleats with a spanner.
Remove the load from the cleats of the appliance before
attempting to adjust them.
When the load has been removed, the cleats can be
adjusted using an SW 17 mm open-ended spanner.x
IMPORTANT!
Horizontal adjustment of the machine by means of the vertically adjustable
feet (spanner/wrench size 27) must be done with care to ensure that the
weight of the machine is evenly distributed on the cleats. This is absolutely
essential in order to avoid displacement or stresses caused by loading on
one side. These stresses can cause, for example, the vertical doors to jam
or can prevent them from being water-tight when closed.
•
Please also read the chapter on “General safety instructions ".
