Document reference MAODS301/E
USER MANUAL
Edition 4 - May 2022
SpeedSys300 ODS301 overspeed detection system
4 - 9
Access levels/permissions
CONFIGURATION OF A SPEEDSYS300 ODS301
3-
On the
Device
tab, under
Password - admin
:
• Select the
Activate
check box control in order to allow the password to be changed.
• Type the new Admin access level password into the data entry field (blank) to the
right of the
Activate
check box control.
Note: Click and hold the
Show password
control to the right of the data entry field
in order to make the password characters visible.
4-
In the overall module information and controls window (right), click the
Enter programming mode
control to enter the programming mode.
When prompted, click
OK
to continue.
Note that the overall module information and controls window (right) updates to display
Device status: Programming – safe state.
5-
In the overall module information and controls window (right), click the
Program device settings
control to program the device settings, that is, change the
password.
When prompted to proceed and overwrite existing parameters, click
OK
to continue.
NOTE:
Programming the device settings will overwrite all existing parameters on the
SpeedSys300 ODS301 module, including the password.
More specifically, the module is completely reconfigured using all of the
parameters configured/changed in the SpeedSys300 software – so it is
important that the password is the only parameter that has been changed (if
that is all that is required).
When prompted to commit the changes, click
OK
to continue.
After the module has been updated:
•
The SpeedSys300 ODS301 module will change from the Programming – safe state
mode back to the Operating mode and run using the updated parameters.
•
The SpeedSys300 ODS301 and SpeedSys300 software will also change from the Admin
access level back to the User access level.
The new Admin access level password must be used the next time that it is required to
change the access level from User to Admin.
NOTE:
Please note that once the Admin access level password is changed, it is the user’s
responsibility to manage (remember) the new password, as it cannot be
changed/reset remotely.
Should the Admin access level password become lost, the only way for the
SpeedSys300 ODS301 module to be “reset” is to return the module to Meggitt SA.
E
NTERING
THE
PROGRAMMING
MODE
WILL
FORCE
THE
S
PEED
S
YS
300 ODS301
MODULE
AND
ITS
OUTPUTS
INTO
THEIR
SAFE
STATE
. A
CCORDINGLY
, I
T
IS
HIGHLY
RECOMMENDED
THAT
MODULE
PROGRAMMING
IS
ONLY
PERFORMED
IN
ACCORDANCE
WITH
THE
OPERATING
PROCEDURES
FOR
THE
MACHINERY
BEING
MONITORED
AND
THAT
APPROPRIATE
PRECAUTIONS
ARE
TAKEN
AT
THE
CONTROL
SYSTEM
LEVEL
(
SUCH
AS
DCS
OR
PLC).
Summary of Contents for vibro-meter SpeedSys300 ODS301
Page 118: ...THIS PAGE INTENTIONALLY LEFT BLANK...
Page 126: ...THIS PAGE INTENTIONALLY LEFT BLANK...
