Manual
2.2
IMPORTANT HINTS FOR PRESENTER OPERATION
2.2.1 PAPER WIDTH
Paper width smaller as specified cannot be used due to the presenter paper guides.
2.2.2 TICKET LENGTH
The minimum ticket length is determined by the distance between the print head and the exit sensor and is 58 mm. The
maximum ticket length is 120 mm with full specification. If the ticket length is chosen to be longer, there is a risk that the
loop will collapse and a disruption will occur, especially when there is high humidity. Larger ticket lengths must be
precisely tested in the application. In the case of very long tickets, it may be possible to work with an additional paper
guide.
Please ask.
2.2.3 PAPER THICKNESS
To create a loop, the paper must have the CORRECT rigidity. If the paper is too soft, it may not be properly transported into
the presenter or the loop collapses and a malfunction occurs. If it is too hard, the presenter cannot “bend” the paper and
therefore cannot create a loop. In addition, the presenter may not be able to feed the paper out. Paper thicker as specified
can be used in dispensing operations without the retract function.
Please ask.
2.2.4 PAPER MEMORY EFFECT
If the printer doesn‘t print for a long time, the paper will bend according to the paper guide in the printer and the external
paper feed. If printing starts again after this standstill, the curvature of the paper on the next ticket may lift the presenter
spring and the ticket cannot be transported into the presenter. We recommend that you “park” the paper in the presenter
while it is idle. For „parking“ purpose, the paper is fed into the presenter. In order to start with a new printout the paper will
then be withdrawn with the command "Retract to ToF".
Pay attention to correct paper gideance!
2.2.5 PRE-PRINTED PAPERS
Tests have shown that preprinted paper behaves more critically under high humidity. This reduces the possible working
range of air humidity from 90% RH to 80% RH.
Only inside coated paper should be used for the presenter.
The paper roll core diameter must be at least 25 mm, while larger diameter would be advantageous for the operation.
GeBE Elektronik und
phone
+49.89.894141-0
GeBE-document-no. GPT-467x-C32-E-MAN-V1.0-1001
Feinwerktechnik GmbH
fax
+49.89.894141-33
date
May 19, 2021
Beethovenstrasse 15
page 11 | 112
82110 Germering
Our general terms of business are to be applied.
Germany
www.gebe.net
Errors and changes reserved.
11
