Manual
20.10 PAPER ROLL HOLDER
The standard paper roll holder has 3 paper axis positions (A, B, C). There is a suitable NearPaperEnd sensor position for
each axis position. The paper core inside diameter of 25 mm is suitable for all positions. Smaller diameters can cause
malfunctions.
Inside coated papers can cause malfunctions, therefore thermal papers are coated on the outside are preferred.
A paper tensioner is required for paper rolls with a diameter of ø >70 mm, or a reduction in the printing speed.
Typical values for a reduction in printing speed for ø150 mm rolls are in:
•
position B: 150 mm/s
•
position C: 180 mm/s
The values are application-specific and must be tested in practice.
Please make sure not to press the green stopper too hard and thus to "jam" the paper roll!
Running length of a paper roll at 82 µm paper thickness:
70 mm
39 m
80 mm
54 m
90 mm
70 m
140 mm
180 m
150 mm
208 m
Position A : for small paper rolls
The paper rolls do not extend beyond the printer dimensions.
Paper roll diameter:
GPT-4672: typ. 70 mm, max. 80 mm
GPT-4673: typ. 70 mm, max. 90 mm
Position B : "above"
Paper roll diameter:
GPT-4672: max. 140 mm
GPT-4673: max. 150 mm
Figure 91
Position C : "below"
Paper roll diameter:
GPT-4672: max. 140 mm
GPT-4673: max. 150 mm
Figure 92
GeBE Elektronik und
phone
+49.89.894141-0
GeBE-document-no. GPT-467x-C32-E-MAN-V1.0-1001
Feinwerktechnik GmbH
fax
+49.89.894141-33
date
May 19, 2021
Beethovenstrasse 15
page 85 | 112
82110 Germering
Our general terms of business are to be applied.
Germany
www.gebe.net
Errors and changes reserved.
85
