Meatest M631, Operation Manual

Page: 13 / 70

M631 Precision RTD Simulator MEATEST
13 Operation manual
Creating a new table
Pressing the
Edit softkey upon plain curve opens this submenu:
Figure 10 New user function
Curve name – table name is set using ▲,▼ (character selection) and ◄, ► (position) cursor keys.
Name may be 8 characters long at most. Softkey „ A <-> a“ switches between uppercase and
lowercase of selected character. Table name has to be set before proceeding to the next step using
SELECT
key.
Unit – user function unit abbreviation is set in the same way as table name only it can be just up to
two characters long. Unit abbreviation has to be set before proceeding to the next step using the
SELECT
key.
Lookup table – a place where you define user function using values in Ω. Table must contain at least
two “user function value → Ω value” points so that a slope of the function can be calculated. Range in
user function mode is given by actual resistance range of the simulator. Browsing through the table is
done by ▲,▼ cursor keys. Editing is done using these contextual softkeys:
Add – create a new point.
Figure 11 User function point editing
Value – user function value in user units. Press the
SELECT
key to proceed.
Resistance
– corresponding Ω value. Range is given by the actual resistance range of the
simulator.
Edit – show the “Equation” panel for selected point to allow editing.
Delete
– delete selected point.
Cancel – deactivate the Lookup Table and allow for curve saving.
Save – closes the table and saves current settings.
Cancel
– closes the table and does not save current settings.