User Manual |
MI-CLARITY3D SA
User Manual |
MI-CLARITY3D
User Manual |
MI-CLARITY3D
©
MASTERIMAGE 3D, Inc.
46
10. Maintenance
WARNING
: To avoid electric shock, ensure the power switch is off and unplug the
power cord prior to cleaning the PFD
Injury may result while working near moving parts. Do not power up the system to
spin the PFD while cleaning the PFD.
CAUTION
: Avoid scratching and damaging the PFD by performing the cleaning
procedure and use cleaning solutions only as outlined in this document.
CAUTION
: Use great care not to touch the image area on either side of the PFD.
Only handle the PFD by the outer edge.
10.1.
Changing the Polarizing Filter Disk (PFD)
Polarizing Filter Disks (PFD)
should be replaced annually
to ensure proper optical
performance. A spare PFD should be kept on hand at all times. Contact your local
equipment provider or MASTERIMAGE office for the supply of new PFDs.
CAUTION
: Use only Polarizing Filter Disks (PFD) with a colored label including the
initials “PC”. These will include “PC-OK” and “AR-PC”. Any PFDs without a “PC”
label must be changed immediately due to risk of possible material failure.
Note:
If turning the PFD to suit the system installation conditions please follow steps
1~4 and 8~14 of this section.
1. Disconnect the MI-CLARITY3D power cord and sync
cable, and move them out from in front of the projector in
order to have good access and lighting to work on the
filter head assembly.
2. Carefully remove the PFD cover by removing the eight
screws. Remove the screws in a sequence starting with
bottom screws and moving on to top screws.
