User Manual |
MI-CLARITY3D SA
User Manual |
MI-CLARITY3D
User Manual |
MI-CLARITY3D
©
MASTERIMAGE 3D, Inc.
13
5.1.1. Unpacking and preparing the MI-CLARITY3D rolling
wheels
5.2.
Orienting the MI-CLARITY3D in front of the Digital
Projector
There are four ways the filter head and main base can be oriented in order to best fit the
space of the projection booth and projector.
Note:
For all orientations described below, the Polarizing Filter Disk (PFD) filter surface
must face the screen
. Some setups may require that the PFD be removed and
turned around in order for the material surface to face the screen.
5.2.1. Orientation 1
– Standard Right
The system is shipped ready to be used in
“Standard Right” orientation with the control
panel facing the right side of the projector.
By using the adjustment slots in the filter motor mount plate, the PDF can be moved
laterally by up to 2 inches, for fine adjustment of position relative to the projector lens.
This configuration is the most commonly used setup for all projector types. The images
below illustrate the standard right orientation, as well as a standard right orientation that
has been adjusted/extended toward the projector.
MI-CLARITY3D Rolling Wheel
The unit is shipped with the rolling wheels locked. After
unpacking, turn the orange rings in the wheel assembly to the
left (clockwise) in order to raise the locking pads and allow the
unit to be rolled easily.
