User Manual |
MI-CLARITY3D SA
User Manual |
MI-CLARITY3D
User Manual |
MI-CLARITY3D
©
MASTERIMAGE 3D, Inc.
17
Result:
When in position, the MI-CLARITY3D Filter Head Assembly (FHA) should be
parallel to the projector lens from both the top and side views. Make sure all motor
mount screws and nuts are tight.
5.3.1. Fine-adjusting the Image Position on the MI-
CLARITY3D PFD
CAUTION
: Do not make position adjustments while the PFD is turning.
Note:
To prevent burning the filter, use a darker image for this setup and do not expose
the stationary PFD to the image for more than 30 seconds at a time.
The PFD cover should be approximately ¼ to ½ inch away from the projector
lens when viewed from the side.
1. Project an image onto the screen (see Note above).
2. Pushing the Up or Down arrow button briefly, fine-adjust the position of the image on
the MI-CLARITY3D PFD so that it is centered just below the top edge of the PFD
area and equally spaced on the left and right sides.
The image below illustrates how the projected image should be positioned on the
MI-CLARITY3D PFD.
Note:
This switch can only be used when the system is in READY status.
When the Up arrow switch is pressed and held, the up motion of the filter
head assembly continues to move until the switch is released.
Use extreme caution in adjusting the filter head height for the first time.
The control panel may be on either side of the projector, based on user
access and closest positioning of the filter to the lens.
