MARUTI SUZUKI Vitara Brezza, Manual

Page: 27 / 366

2-8
BEFORE DRIVING
82PH0-74E
NOTE:
• The maximum operating distance of the
remote controller is about 5 m (16 ft.),
but this can vary depending on the sur-
roundings, especially near other trans-
mitting devices such as radio towers or
CB (Citizen’s Band) radios.
• The door locks cannot be operated with
the remote controller if the ignition mode
is other than the “LOCK”(OFF).
• When any door is open, if you push the
lock button on the remote controller, the
exterior buzzer will sound and doors
cannot be locked.
• If you lose one of the remote controllers,
ask your authorised Maruti Suzuki work-
shop as soon as possible for a replace-
ment. Be sure to have your dealer
program the new remote controller code
in your vehicle’s memory so that the old
code is erased.
Car locator function
This function helps in locating the vehicle.
Push both of the lock button (1) and unlock
button (2) for more than 3 seconds. The
turn signal lights will blink for about 27.5
seconds. Also, the siren will sound for
about 27.5 seconds at the same time.
To cancel the car locator function, press
any button (lock or unlock). You can also
change the ignition mode to “ON” to cancel
the car locator function.
NOTE:
The car locator function will not activate
when the ignition mode is “ACC” or “ON” or
pre warning / full blast warning by shock
sensor or alarm is in activated condition.
Keyless unlocking/locking using the
request switches
82PH02011
When the remote controller is within the
operating range described in this section,
you can lock or unlock the doors (including
the tailgate) by pushing the request switch
(1) on the driver’s door handle, front pas-
senger’s door handle or tailgate.
To lock all doors when all doors are
unlocked:
• To lock all doors, push one of the
request switches once.
The turn signal lights will flash once and
the siren will sound once when the doors
are locked.
To unlock a door or all doors:
• Push one of the request switches once
to unlock only one door.
• Push one of the request switches twice
to unlock all doors.
NOTE:
You can switch the function that unlocks all
doors from twice operations to once opera-
tion, and vice versa, via the setting mode
of the information display. For details on
how to use the information display, refer to
“Information Display” in this section.
When the doors are unlocked:
• The turn signal lights will flash twice and
the siren will sound twice.
• If the interior light switch is in the door
position, the interior light will turn on for
about 15 seconds and then fade out. If
you press the engine switch during this
time, the light will start to fade out imme-
diately.
Be sure the doors are locked after you
operate the request switch to lock the
doors.
NOTE:
• If you lock the doors using the request
switch or the lock switch on the keyless
push start system remote controller
when the engine hood is open, the siren
will sound 3 times to remind you.
(1)
EXAMPLE