MARUTI SUZUKI Vitara Brezza, Manual

Page: 116 / 366

3-19
OPERATING YOUR VEHICLE
82PH0-74E
To Change Cruising Speed
Using the accelerator pedal
To reset at a faster cruising speed, accel-
erate to the desired speed using the accel-
erator pedal and push the “SET –” switch
(4). The new speed will be maintained.
Using the brake pedal
To reset at a slower cruising speed, decel-
erate to the desired speed using the brake
pedal and push the “SET –” switch (4). The
new speed will be maintained.
NOTE:
When the brake pedal is depressed, the
“SET” indicator light goes off until reset the
cruising speed.
Using the “RES +” switch or the “SET –”
switch
To reset at a faster cruising speed, press
repeatedly or hold push the “RES +” switch
(3). Vehicle speed will steadily increase.
When you release the switch, the new
speed will be maintained.
To reset at a slower cruising speed, press
repeatedly or hold push the “SET –” switch
(4) until the vehicle has slowed to the
desired speed, then release the switch.
The new speed will be maintained.
NOTE:
You can adjust the set speed by approxi-
mately 1.6 km/h by pushing the “RES +”
switch (3) or the “SET –” switch (4) quickly.
Cancellation of the Cruise Control
The “SET” indicator light will go off and the
cruise control will be cancelled temporarily
with following procedures:
• Push the “CANCEL” switch (2).
• Depress the brake pedal.
• Depress the clutch pedal.
• The vehicle speed falls more than about
20 percent from the set speed.
• Any time the vehicle speed falls below
40 km/h.
To resume the previously set speed, push
the “RES +” switch (3) and “SET” indicator
light will be turned ON Besides, the vehicle
speed has to be above 40 km/h when the
vehicle is not in the above conditions.
To turn off the cruise control system, push
the “CRUISE” switch (1) and make sure
the “CRUISE” indicator light is off.
Also, if the malfunction indicator light in the
instrument cluster comes on or blinks, the
cruise control system will be turned off.
NOTE:
If you turn off the cruise control system, the
previously set speed in the memory is
cleared. Reset your cruising speed again.
Parking Sensors (if equipped)
82PH03009
(1) Symbol representing an obstacle
detected by parking sensor*
* This symbol represents an obstacle
that is located to the right rear of
the vehicle.
• The parking sensor system uses ultra-
sonic sensors to detect obstacles near
the rear bumper. If obstacles are sensed
while you are parking or moving the
vehicle slowly / In reverse gear, the sys-
tem warns you by sounding a buzzer
and displaying symbols representing the
obstacles on the information display in
the instrument cluster.
• The system emits an ultrasonic wave
and the relevant sensor detects the
return of the wave reflected by an obsta-
cle. The system measures the time
taken by the ultrasonic wave to reach the
obstacle and return from it, from which it
determines the obstacle’s position.
• The parking sensor function can be used
when you turn the ignition switch to the
“ON” position or press the engine switch
(1)
EXAMPLE