Revision 1.8.3
Page 181
To program the - to sender gauge resistance, use the Scroll Up (
) or Scroll Down (
) keys to
move the highlighted cursor over
the “Gauge Resistance, - to Sender:” menu item. Then, press the
Enter key (
) to move the highlight over the numerical resistance value
. Use the “Increase” and
“Decrease” keys to change the value to the measured resistance value, and finally, press the Enter
key (
) to confirm your selection and store the value within the TLA100.
Figure 201
– Configuring the - to Sender Gauge Resistance
