DSM570
User’s Manual
Page 116
Revision 1.8.3
•
Fuel
•
Fresh Water
•
Waste Water
•
Live Well
•
Oil
•
Black Water
•
Reserved-1
…
Reserved-7
– These values may be used when the contents of the tank
does not fit into one of the categories above.
6.13.2.1.9
Data Damping Period
If the channel’s Function is set to Tank, the default data damping period is 16.0 seconds. If the
channel’s Function is set to Pressure/Vacuum, the default data damping period is 3.0 seconds.
6.13.2.2
Channel #0-5 (Pressure/Vacuum)
This secti
on describes the channel configuration menu when the channel‘s Function has been set to
“Pressure/Vacuum” mode. The Channel #0-5 (Pressure/Vacuum Mode) menu is shown below.
Figure 107
– FPM100 Channel (Pressure/Vacuum Mode) Configuration
6.13.2.2.1
Function
You can set the channel’s Function to “Disabled”, “Tank”, or “Pressure/Vacuum”. This section of the
manual assumes that the channel’s function has been set to “Pressure/Vacuum”.
6.13.2.2.2
Instance
This entry sets the instance number to be used in the Pressure message. This entry may be set to ay
value between 0 and 252.
6.13.2.2.3
Label
A label may be assigned to each channel of the FPM100 as an aid to identifying the pressure that is
being displayed. Typically, this label will describe the function or location of the pressure sensor.
