Installation manual - Ecotype - 41
C
C
h
h
a
a
p
p
t
t
e
e
r
r
4
4
A
CCESSORY EQUIPMENT INSTALLATION
4.1 Automatic rear closing system
Note:
The automatic rear closing system can be provided only together with the double pulling bow.
The covering system is available with an innovative rear closing
system which avoids that the operator has to position by hand the
end part of the tarpaulin when securing the tipper body.
This system requires a close attention during the fixing operation of
the tarpaulin on the front side of the tipper body.
Here below the operations to perform:
•
Move out (by hand or electrically depending on the installed
covering version) and cover the tipper body stopping the pulling
bow at a distance from the tailgate that corresponds to the
length of the closing system when completely closed.
•
Tighten now the front part of the tarpaulin.
•
Fix the lateral PE flat strip (2) on the fixing screws of the front
supports (1).
•
Fix the tarpaulin on the top of the front tubular frame employing
the specific clamping plate (3) and rivets(4).
•
Cut the excess tarpaulin part off.
Now it is possible to set up the automatic rear closing system in order
that while closing the tarpaulin manually or electrically, arriving at the
end stop, the rear closure comes down automatically.
WARNING!
For carrying out certain maintenance work the access to the internal space of the tipper body
is required. Make sure that the internal space is empty and clean to avoid any sliding and
falling. Wear suitable protective clothing.
ALL MAINTENANCE WORK MUST BE PERFORMED WITH STATIONARY VEHICLE AND
DISCONNECTED
EQUIPMENT’S
DO NOT WALK ON THE TARPAULIN!
Marcolin Covering s.r.l. denies any responsibility.
•
Unfold the tarpaulin (manually or electrically depending on the version) and cover the tipper body (fig. 1).
pic. 1
