24 - Installation manual - Ecotype
3.4.4 Steel cable tightening up
After positioning the steel cables, tighten them up by applying the process described for the rear drive pulleys in order to
make possible the proper sliding of the covering.
HAND OPERATED VERSION for tipper body length < 8 m
To do this you need to act on two front supports. In fact, the anterior drive pulleys have been developed and manufactured in
order to allow the operator to adjust the steel cable tension.
Operating alternately on the two drive pulleys proceed as follows:
•
Use a 10 Nm torque wrench to tighten the screw placed on the front side (
1
) of the drive pulley. As a consequence, the
drive pulleys (
2
) and the slide part move backwards, in this way tightening up the steel cable.
Body length > 8 m
