Installation manual - Ecotype - 47
4.3.3 Installing hooks and side guides
For installation, proceed as described below:
1. Unfold the covering to cover the body entirely.
2. Determine where to fix the hooks.
1. Place the hook support
(2)
on the side of the support foot bracket
(1)
.
2. Secure the bracket to the support using the round head screws
(3)
provided.
Note:
Use medium-strength Loxeal 54.03 thread locking fluid on the round head screws (3) provided.
3. Secure the hook to the support using the hex bolt
(4)
and the self-locking nut
(5)
provided.
IMPORTANT!
Leave a minimum clearance of
1 mm
between the nut and the side plate of the hook.
After determining the height of the hooks, you can install the Z-section
guides on both sides of the body.
IMPORTANT!
The standard size of the Z-section guide is 30x30x3 mm.
Different sizes could jeopardize the correct operation of the
anchoring system and damage the covering tarpaulin.
4. Place the Z-section guide
(7)
at approx. 8 mm from the top of the hook
tip, as show in figure.
→
Note:
The installation position of the Z-section guide is the same with both
normal and lowered cables.
