Installation manual - Ecotype - 53
5.5 Troubleshooting table for electrically operated covering system
The following table lists some possible break downs or operating troubles.
Type of fault
Possible cause
Possible solution
The motor is not running after
pressing a button of the "TX
MARCOLIN"
radio
remote
control or turning the control
selector of the Control Box
Emergency engaged.
Check that the emergency button is reset.
Incorrect electrical connections.
Check the electrical connections (positive -
negative of the battery).
The safety fuse has blown.
Check the fuses. One is located in line with
the power supply, the other is inside the
Control Box.
The contacts of the motor have become
disconnected.
Check that the contacts of the motor are
firmly connected.
When you press a button on the
"TX MARCOLIN" radio remote
control, the red indicator light
does not come on.
The battery of the "TX MARCOLIN" radio
remote control is flat.
Replace the battery of the "TX MARCOLIN"
radio remote control.
If the case, reprogram the "TX MARCOLIN"
radio
remote
control
following
the
instructions described at para. 3.9.5
The Control Box operates only
with the control selector and not
with the “TX MARCOLIN” radio
remote control.
The "TX MARCOLIN" radio remote control
has lost the correct programming.
Reprogram the "TX MARCOLIN" radio
remote control following the instructions
described at para. 3.9.5
If, after reprogramming, the radio remote
control continues not to work, check the
Control Box for faults.
The Control Box appears to be
working (you can hear its relay
acting) but the motor is not
running.
The electrical contacts may be oxidised.
WARNING!
Isolate the power supply before cleaning.
WARNING!
Isolate the power supply before cleaning
(press the emergency button or disconnect
the plug from the tractor).
Check that the electrical contacts of the
contact plate (between body and frame)
are not dirty or oxidised.
Check that the electrical contacts of motor
and Control Box are not dirty or oxidised.
If necessary, clean with a dry cloth and
protect with synthetic moisture-repellent
grease.
Stubborn oxidation may be removed using
very fine sandpaper (400 or finer)
Burnt motor
Replace the motor. To do so, contact
Marcolin
Technical
Support
or
an
authorised service centre.
A cable terminal or an eyelet of an
electrical wire might have broken, or the
electrical cables might be broken or
damaged.
Check the cable terminals on the cables of
the motor and the contact plate are not
damaged or broken.
Check that the wiring is free from faults.
Restore the correct operation of the circuit
by replacing any damaged parts at a
service centre or an at electrical vehicle
repair shop.
