38 - Installation manual - Ecotype
3.9.9 Restoring of standard operative conditions
CAUTION!
Before restarting the machine correct the situation causing the event.
For restoring the machine after an
emergency situation with pressing
on the red mushroom pushbutton
no. 6 proceed as follows:
•
Insert the unlocking key in the
emergency pushbutton of the
Control Box
•
Turn the key in clockwise
direction and pull out the
pushbutton.
3.9.10 Machine stop in safety conditions
•
Release the control pushbutton on the Control Box or on the r
emote control “TX MARCOLIN”.
•
Set the machine in EMERGENCY STOP by pressing the mushroom pushbutton stated as no.6 on the Control Box.
•
For setting the machine in SAFETY SHUTDOWN (if leaving the vehicle is required) remove the key from the emergency
pushbutton (no. 6).
3.9.11 Retraction of the Ecotype tarpaulin for uncovering the tipper body
In the starting position of the system the tarpaulin is moved out on the tipper body. To fold it operate as follows:
•
Remove all rubber straps (if provided for the version installed on your vehicle) from the lateral hooking points so that the
covering can be moved freely.
•
Insert the key in the emergency pushbutton.
•
Turn the key in CLOCKWISE direction to unlock the emergency pushbutton for giving the consent to restart the
machine:
By starting the Control Box gives out an acoustic signal.
On remote control “TX MARCOLIN”
: PRESS THE PUSHBUTTON no. 1 (UNCOVERED)
On Control Box
: TURN THE SELECTOR to the left (
UNCOVERED
)
•
Fold the tarpaulin completely and release the control button. The Control Box is equipped with an automatic motor shut-
down when covering reaches the end stop.
•
Carry out a quick but attentive control to Check that everything is in good order before starting the tilting movement of
the tipper body.
3.9.12 How do you interrupt the machine operations?
Follow the process described in paragraph 3.9.7 .
3.9.13 How do you stop the machine in case of emergency?
Follow the process described in paragraph 3.9.8 .
3.9.14 Machine stop in safety conditions
Follow the process described in paragraph 3.9.10 .
