Installation manual - Ecotype - 37
3.9.5 Reprogramming the "TX MARCOLIN" radio remote control
Should it become necessary to
reprogram a “TX
MARCOLIN” radio remote control, please follow the
procedure below.
1. Enter programming mode by pressing
7 times
the
Control Box LED button (no. 5 in the figure). After
having pressed the button 7 times, the Control Box will
beep intermittently and the LED button will flash.
2.
Now press any button of the “TX MARCOLIN” radio
remote control: The Control Box will beep again and the
LED button will turn off for one second, then it will turn
back on and remain lit. The “TX MARCOLIN” radio
remote control is now programmed.
3.
Check the correct operation of the “TX MARCOLIN”
radio remote control by testing the operation of the
motor in the two directions by opening and closing the
covering.
In case of errors or incorrect operation, contact Marcolin Covering Support Service or an authorized workshop.
3.9.6 Unfold the Ecotype tarpaulin for covering the tipper body
In the starting position of the system the tarpaulin is folded on the front part of the tipper body. To move it out operate as
follows:
•
Check that the upper edges of the tipper body are free from any obstacle.
•
Remove all rubber straps (if provided for the version installed on your vehicle) from the front hooks so that the covering
can be moved freely.
•
Insert the key in the emergency pushbutton.
•
Turn the key in CLOCKWISE direction to unlock the emergency pushbutton for giving the consent to restart the
machine:
By starting the Control Box gives out an acoustic signal.
On remote
control “TX MARCOLIN”
: PRESS THE PUSHBUTTON no. 2 (
COVERED
)
On Control Box
: TURN THE SELECTOR TO THE RIGHT (
COVERED
)
•
Move out the tarpaulin completely and release the control button. The Control Box is equipped with an automatic motor
shut-down when covering reaches the end stop.
•
Close the covering on the rear side (in case of automatic rear closing system this operation takes place automatically).
•
Hook the rubber straps into the lateral hooking points to fasten the tarpaulin for the transport way (if provided for the
version installed on the vehicle).
•
Press the emergency mushroom pushbutton and remove the key.
•
Carry out a quick but attentive control, especially of the automatic hookings, to check that everything is in good order
before moving the vehicle on the road.
3.9.7 Interruption of machine operations
To stop the movement of the covering, just release the control selector of the Control Box or release the button of the "TX
MARCOLIN" radio remote control.
3.9.8 How do you stop the machine in case of emergency?
For setting the machine in
EMERGENCY STOP
press instinctively the mushroom pushbutton stated as no. 6 on the Control
Box.
CAUTION!
It is strictly forbidden to leave the machine running unattended.
The manufacturer denies any liability.
