Manitou MSI 40, Operator'S Manual

Page: 51 / 116

2 - 23
3 - I
NSTUMENT PANEL
A - Fuel level gauge.
B - Hourmeter.
C - Water temperature gauge.
D - Green indicator lamp.
E - Red engine oil pressure lamp.
F - Red alternator charge lamp.
G - Blue main beam lamp.
H - Red air filter clog lamp.
I - Red hydrostatic transmission oil filter clog lamp.
J - Fuses box.
A - FUEL LEVEL GAUGE
B - HOURMETER
It shows the number of hours the fork lift truck has run. The hours are shown on the dial up to a multiple of thousand.
The moving tell-tale shows the good working order of the apparatus.
C - WATER TEMPERATURE GAUGE
When the truck works in normal conditions the needle of the indicator should indicate 80° to 90° C.
If the needle indicates an abnormally high temperature (100° C maximum) , stop the engine immediately and investigate
the cooling system for the cause of the malfunction.
D - GREEN INDICATOR LAMP
It is illuminated when the indicators are on and indicates that they are functioning properly.
E - RED ENGINE OIL PRESSURE LAMP
This lamp is illuminated when the ignition switch is in the ON position and should go out as soon as the fork lift truck
starts. If this lamp stays on when the engine is running, stop the fork lift truck immediately and look for the cause (see oil
level in engine crankcase).
F - RED ALTERNATOR CHARGE LAMP
This lamp is illuminated when the ignition switch is in the ON position and should go out as soon as the fork lift truck
starts. If this lamp stays on when the engine is running, stop the fork lift truck immediately and check the electrical circuit
as well as the alternator belt.
G - BLUE MAIN BEAM LAMP (OPTION)
The lamp is illuminated when lights are on main beam.
H - RED AIR FILTER CLOG LAMP
This lamp provides the operator with information about the condition of the filter cartridge. If this cartridge is clogged the
lamp comes on (See cleaning and replacement requirements in chapter : FILTERS CARTRIDGES AND BELTS in
paragraph : 3 - MAINTENANCE).
I - RED HYDROSTATIC TRANSMISSION OIL FILTER CLOG LAMP
This lamp provides the operator with information about the condition of the filter cartridge. If this cartridge is clogged the
lamp comes on (See cleaning and replacement requirements in chapter : FILTERS CARTRIDGES AND BELTS in
paragraph : 3 - MAINTENANCE).
NOTE : This lamp comes on by cold weather or when starting the fork lift truck, it goes off when the hydraulic oil reach
the temperature of functionning.