Ref.: WB-VL-65 DSP LX Premium - OM Ver.1.6 (B2927)
39
Move the Distance/Diameter measuring rod & touch the inner plane profile (Ref.Fig.21)
of the Rim properly and hold it for few seconds until Audio indication and then move the
Distance/Diameter measuring rod to its home position. The system will go to next
screen.
Fig. 47
Move the Width measuring rod and touch the outer plane (profile) (Ref. Fig.22) of the
Rim properly and hold it for few seconds until Audio indication. User will be prompted to
save the values as shown below:
Fig. 48
Press
key to save the Width calibration values. Then move the Width measuring
rod to its home position. Mount a Wheel & ensure the Rim Distance & Width measured
in
RIM PARAMETERS
screen are as per the Wheel Width specifications within
tolerance limit of ±0.3”.
9.4.
WHEEL TRACKING TEST
This feature should be used only by authorised Service personnel. Hence User
should not enter into this Option
9.5.
DISTANCE ROD TEST
This feature is applicable only for Manufacturer. Hence User should not enter
into this Option
9.6.
SELF TEST
This feature is applicable only for Manufacturer. Hence User should not enter
into this Option
9.7.
SENSOR TEST
This feature should be used only by authorised Service personnel. Hence User
should not enter into this module
9.8.
LASER & TORCH SETTING (Applicable for model)
This feature should be used only by authorised Service personnel. Hence User
should not enter into this module
9.9.
DUTY CYCLE TEST
This feature should be used only by authorised Service personnel. Hence User
should not enter into this module
