Ref.: WB-VL-65 DSP LX Premium - OM Ver.1.6 (B2927)
18
7. OPERATION
Only permit qualified personnel to operate, maintain or repair the Balancer
Do not lift the Wheel guard until the wheel is completely stopped
Always ensure that the wheels are mounted properly. The QCLN must be tightened
firmly before spinning the wheel
Pay attention while lifting heavy wheels. Heavy loads should not be lifted without
assistance
Always comply with the applicable accident prevention regulations
Never overload the Wheel balancer
Do not hammer or hit any part of the equipment with Weight plier, Tools etc.
Avoid dropping of wheels heavily on the shaft while mounting & removing, which may
affect the accuracy of the equipment
DO NOT apply the Mechanical brake while the Motor is running. It should be used only
for adding weights or mounting/removing wheels
If any error message is displayed, resolve the error as guided in the Trouble shooting
(Chapter 13) and then press any key to return after clearing the indicated error
7.1.
DEFECTS / MALFUNCTIONS
In case of defects or malfunctions such as abnormal noise / improper display /
Keypad not responding etc., turn OFF the mains and contact qualified Service
personnel
7.2.
PREPARATION OF WHEEL FOR BALANCING
Manufacturer is not liable for in-accurate balancing of re-treaded tyre or wheel
with more runout
1.
Check for the correct tyre size and weight are mounted on the Balancer.
2.
Check for proper air pressure of the tyre, if required inflate the tyre to the
recommended pressure.
3.
Remove if any foreign materials are present in the tyre treads.
4.
Clean the rim and tyre free of excessive dirt and stones. The central bore and
face of the rim must be thoroughly cleaned to ensure proper fitment with the
Wheel mounting accessories.
5.
Dismount all the existing wheel balancing weights from the rim.
7.3.
MOUNTING OF WHEEL ON MCD
Pay attention while lifting heavy wheels. Heavy loads should not be lifted
without assistance
Avoid dropping of wheels heavily on the shaft while mounting & removing,
which may affect the accuracy of the equipment
Accurate balancing depends on the proper mounting of wheel on to the shaft
