Ref.: WB-VL-65 DSP LX Premium - OM Ver.1.6 (B2927)
27
When the top most position is reached,
symbol will popup above the wheel
image. Now add the indicated weight at the indicated position on to the rim by
clipping/ pasting the weight & hammer it using Weight plier.
Weight adding location
@ 12 0‟ clock (Top)
Weight adding location
@ 6 0‟ clock (Bottom)
Sticker weight addition
using Holder
Fig. 25
Do not lift the Wheel guard until the wheel is completely stopped
The weights must be fixed firmly on to the rim for proper balancing
and to avoid repeated runs
In case of
Static balancing
, only Inner plane will be displayed &
balanced
By default, Sticker weight holder mode will be available. Use
button to toggle between Sticker weight holder mode & Laser mode
In Sticker weight mode & if either
Auto Dia
or
Auto Width
is disabled,
the Unbalance position will be shown at the bottom position only
The Torch can be switched On/Off as desired by using
button
In Laser mode, unbalance position will be indicated for Inner & Inner
most position
Repeat the above steps for Outer plane also. Spin the wheel again to check
whether the wheel is now balanced. Normally in one run, the wheel should
get balanced. However if the unbalance is more, it may require more than one
balancing run.
Once the wheel is balanced, system indicates OK in the respective window.
The Job number window automatically gets incremented when the wheel is
completely balanced in both Inner & Outer planes.
In case of any abnormality during spinning of wheel, press
key to
stop the Motor
If Distance rod is not in home position, “
Distance rod is not in home
position
” will be displayed. Balancing will not be performed unless
Distance rod is restored to its home position
Wheel guard should be kept closed, otherwise the system will prompt
“
Wheel Guard Not closed
” message
If the unbalance is more or weight is not added exactly in the correct
position, it may require more than one balancing run
