MAHA SA 2 Euro, Operation & Maintenance Manual

Page: 25 / 134

Eurosystem / Profi-LON Profi-LON Operation
3.6 D1 E101BA1-GB09
5 Prepare brake test
a) Drive with front axle onto brake tester. Both sensor rollers must be pushed down.
b) Release brake.
c) Press clutch or place gear shift to neutral.
Automatic transmission should be placed to Neutral-Position (N) .
⇒
Roller drive starts automatically once both sensor rollers are pushed down. Yellow
READY lamp lights up when brake test can be started.
6 Activate pointer stop
If pointer stop is activated pointer will indicate measurement value until it is stored or deleted.
After each measurement the pointer stop is switched off again at final evaluation by pressing
the Auto-Off-key and must be, if desired, reactivated again before each new measurement.
Taste wieder ausgeschaltet und muss daher, falls gewünscht, vor jeder neuen Messung
wieder aktiviert werden. Press
 
key of remote control.
7 Ovality test (if desired)
See section 3.4 “Ovality Test”.
8 Brake test
a) Slowly push down brake pedal until rollers switch off at preset slip.
b) Release brake pedal immediately.
⇒
Max. measured brake force appears on the
display and remains visible for the preset time.
→
Rollers start up again and pointers return to
zero point.
→
READY lamp lights up. Test stand is ready for
next measurement.
Slip is not reached?
If brake force is not sufficient to reach slip switch off drive using Motor-Off key of remote
control.
→
Max. brake value is displayed.
9 Store measurement values
Brake values must be allocated to respective axles. Use appropriate storing keys on remote
control.
Vehicle must be on roller set. If vehicle is lifted out of roller set during brake test drive onto
roller set again to store the measurement values.
Slip is not reached?
If slip is not reached during brake test max. brake force can be stored during test by pressing
appropriate storing key on remote control.