214735
78
Revision A
1019351
A
B
Figure 4.61: Hydraulic Center-Link without
Self-Alignment Kit
8.
For hydraulic center-link without self-alignment:
Relocate pin (A) in frame linkage as required to raise
the center-link (B) until the hook is above the
attachment pin on the header.
IMPORTANT:
If the center-link is too low, it may contact the header as
the windrower approaches the header for hookup.
1000780
B
A
Figure 4.62: Header Support
9.
Drive the windrower slowly forward so the feet (A) on
the windrower enter the supports (B) on the header.
Continue to drive slowly forward until the feet engage
the supports, and the header nudges forward.
1018906
A
B
C
D
Figure 4.63: Hydraulic Center-Link
10.
For hydraulic center-link with self-alignment:
Adjust
position of the center-link cylinder (A) with switches on
the GSL until the hook (B) is above the header
attachment pin.
11.
For hydraulic center-link without self-alignment:
Push down on rod end of link cylinder (C) until hook
engages and locks onto header pin.
IMPORTANT:
Hook release (D) must be down to enable self-locking
mechanism. If the release is open (up), manually push it
down after hook engages header pin.
12.
For hydraulic center-link with self-alignment:
Lower
center-link (A) onto the header with REEL DOWN
switch on the GSL until it locks into position (hook
release [D] is down).
13.
For hydraulic center-link with self-alignment:
Check
that center-link is locked onto header by pressing the
REEL UP switch on the GSL.