5.5 Centering the Reel
Refer to the topic for header type:
•
5.5.1 Centering Double Reels, page 55
•
5.5.2 Centering Single Reels, page 55
5.5.1 Centering Double Reels
WARNING
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
before making adjustments to machine.
1. Measure clearances at locations (A) between reels and
both endsheets. The clearances should be the same
if the reels are centered. If the reels are not centered,
proceed to Step
Figure 5.13: Double Reel Measurement
Locations
2. Loosen bolts (A) on each brace (B) located on both
sides of the reel support arm (C).
3. Move the forward end of the reel center support arm (C)
laterally as required, to center both reels.
4. Tighten bolts (A) and torque to 359 N
·
m (265 lbf
·
ft).
Figure 5.14: Reel Center Support Arm
5.5.2 Centering Single Reels
WARNING
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
before making adjustments to machine.
214047
55
Revision A
