9. Drive the windrower slowly forward until the draper
header supports (A) enter the header legs (B).
Continue driving slowly forward until lift linkages
contact the support plates in the header legs and the
header nudges forward.
10. Ensure that lift linkages are properly engaged in header
legs and are contacting the support plates.
Figure 3.18: Header Leg and Draper Header
Support
11.
For
hydraulic
center-link
with
optional
self-alignment:
a. Adjust position of the center-link cylinder (A) with
the switches on the GSL until the hook (B) is above
the header attachment pin.
IMPORTANT:
Hook release (C) must be down to enable
self-locking mechanism.
b. If the hook release (C) is open (up), stop the
engine and remove ignition key. Manually push
the hook release (C) down after hook engages the
header pin.
c. Lower center-link (A) onto the header with REEL
DOWN switch on the GSL until it locks into position
(hook release [C] is down).
d. Check that center-link is locked onto header by
pressing the REEL UP switch on the GSL.
Figure 3.19: Center-Link
214047
24
Revision A
