MacDon D1X Series, Assembly Instructions Manual

Page: 105 / 108

Predelivery Checklist
Perform these checks prior to delivery to your Customer. Adjustments are normally not required as the machine
is factory-assembled and adjusted. If adjustments are required, refer to the appropriate page number in this
manual. The completed Checklist should be retained by either the Operator or the Dealer.
CAUTION
Carefully follow the instructions given. Be alert for safety related messages that bring your attention to
hazards and unsafe practices.
Header Serial Number:
Table 1 Predelivery Checklist for D125 X and D1 XL-Series Draper Headers – North America
 Item Reference
Check for shipping damage or missing parts. Be sure all
shipping dunnage is removed.
—
Check for loose hardware. Tighten to required torque. 8.1 Torque Speci fi cations, page 79
Check tire pressure (Transport/Stabilizer Option).
5.1 Checking Tire Pressure: Transport and
Stabilizer Wheels, page 47
Check wheel bolt torque (Transport/Stabilizer Option). 5.2 Checking Wheel Bolt Torque, page 48
Check knife drive box breather position. 5.3 Checking Knife Drive Box, page 49
Check knife drive box lube level. 5.3 Checking Knife Drive Box, page 49
Check knife drive belt(s) tension.
5.4 Checking and Adjusting Knife Drive Belt
Tension, page 51
Check if reel is centered between header endsheets. 5.5 Centering the Reel, page 55
Grease all bearings and U-joints. 5.12 Lubricating the Header, page 69
Check draper tension. 5.6 Adjusting Draper Tension, page 57
Check draper seal.
5.7 Checking and Adjusting Draper Seal, page
59
Check reel tine to cutterbar clearance. 5.10.1 Measuring Reel Clearance, page 63
Check if skid shoes are evenly adjusted an appropriate
setting for
fi rst crop.
5.8 Checking and Adjusting Skid Shoe Settings,
page 61
Check fi t of endshields.
5.11 Checking and Adjusting Endshields, page
66
Check that header is level. 5.9 Levelling the Header, page 62
Check hydraulic hose and wiring harness routing for
clearance when raising or lowering header and reel.
—
Run-up procedure 6 Running up the Header, page 75
Check if the knife drive pulley(s) is rotating in proper
direction: clockwise on left-hand side; counterclockwise
on right-hand side (double knife only).
5.4 Checking and Adjusting Knife Drive Belt
Tension, page 51
Check if lights are functional.
—
214047
97
Revision A