215651
120
Revision B
5.3.6
Lubrication
Greasing points are marked on the machine by decals showing a grease gun and the grease interval in hours of operation.
Figure 5.5: Grease Interval Decal
Refer to the inside back cover for recommended lubricants.
Log hours of operation and use the Maintenance Record
provided to keep a record of scheduled maintenance. Refer to
5.3.1 Maintenance Schedule/Record, page 116
.
Lubricating Header
Greasing points are marked on the machine by decals showing a grease gun and the grease interval in hours of operation.
DANGER
To prevent injury or death from the unexpected start-up of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
Figure 5.6: Grease Point Location Decal
1.
Open the driveshields at the ends of the header to access
greasing points. For instructions, refer to
.
2.
Refer to the grease point location decal for the locations of
the greasing points on the header. For service intervals,
refer to
Lubrication Service Intervals, page 121
.
3.
Wipe each grease fitting with a clean cloth before
lubricating to avoid injecting dirt and grit.
4.
Inject grease through each fitting with a grease gun until
grease overflows the fitting, except where noted.
IMPORTANT:
Use only the recommended lubricants specified in this
manual. For information, refer to the inside back cover of
this manual.
5.
Leave excess grease on the fittings to keep out dirt.
6.
Replace any loose or broken fittings immediately.
7.
Remove and thoroughly clean any fitting that will not take
grease. Also clean the lubricant passageway. Replace the
fitting if necessary.
