215651
191
Revision B
$
%
Figure 5.144: Draper Connector
2.
Attach screws (A) (with the heads facing the center
opening), tube connectors (B), and nuts to the draper joint.
NOTE:
Use channel lock pliers to bring tube connectors (B)
together. Place the draper seal under the cutterbar.
$
Figure 5.145: Draper Tensioner
3.
Tighten the draper by turning adjuster bolt (A) clockwise.
For instructions, refer to
.
4.
Disengage the reel and header safety props.
WARNING
Check to be sure all bystanders have cleared the area.
5.
Start the engine and lower the header and reel.
6.
Run machine to verify that draper tracks correctly. Refer to
5.7.4 Adjusting Draper Tracking, page 179
if additional
adjustment is necessary.
Draper Deck Drive Roller
Removing Draper Drive Roller
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator
’
s seat, and always engage the safety props before going under the
machine for any reason.
WARNING
Check to be sure all bystanders have cleared the area.
1.
Start the engine.
2.
If the draper connector is not visible, engage the header until the connector is accessible (preferably close to the
outboard end of the deck).
3.
Raise the reel fully.
4.
Raise the header fully.
5.
Shut down the engine, and remove the key from the ignition.
6.
Engage the reel safety props. For instructions, refer to
Engaging Reel Safety Props, page 35
.
