215651
121
Revision B
Lubrication Service Intervals
Lubricate the components detailed in the following lubrication service intervals for optimal performance.
Every 10 Hours
Lubricate the following components every 10 hours unless otherwise stated.
Use high temperature extreme pressure (EP2) performance grease with 1% max molybdenum disulphide (NLGI Grade 2)
lithium base unless otherwise specified.
Figure 5.7: Lubricating Knife
Knife:
Lubricate the knife every 10 hours or daily, except in
sandy conditions. In sandy conditions, lubricate it less as sand
will stick to the lubricant.
%
Figure 5.8: Every 10 Hours
A - Drive Roller Bearing
IMPORTANT:
When greasing the drive roller bearing, clear any debris and excess grease from
around the bearing and bearing housing. Inspect the condition of the bearing
and bearing housing. Grease the feed draper drive roller bearing until grease
comes out of the seal. Wipe any excess grease from area after greasing.
B - Idler Roller Bearing (Both Sides)
IMPORTANT:
When greasing the idler roller bearings, clear any debris and excess grease from around the
bearing housing. Inspect the condition of the roller and bearing housing. Grease the feed
draper idler roller bearing until grease comes out of the seal. Initial greasing on a new
header may require additional grease (may require 5
–
10 pumps). Wipe any excess grease
from area after greasing.
