215651
196
Revision B
%
$
&
Figure 5.156: Aft Deflector
4.
Open the endshield.
5.
Remove two Torx
®
head screws (A) and lock nuts.
6.
Remove three carriage bolts (B) and lock nuts, and remove
aft deflector (C).
%
$
Figure 5.157: Forward Deflector
–
Left Side
7.
Remove four screws (A) and remove deflector (B).
8.
Repeat for the opposite end of the header.
Installing Narrow Draper Deflectors
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator
’
s seat, and always engage the safety props before going under the
machine for any reason.
DANGER
Never start or move the machine until you are sure that all bystanders have cleared the area.
1.
Raise the reel to its full height and lower the header to the ground.
2.
If hydraulic deck shift is installed, shift the decks to create a work space at one end of the header. Refer to
Shifting Decks Hydraulically, page 79
for instructions if hydraulic deck shift is installed.
3.
Stop the engine, remove the key, and engage the reel safety props.
