215651
41
Revision B
Adjusting the endshield
$
%
$
$
$
Figure 3.15: Left Endshield Support Tube on D1X
Series Header
2.
Inside the endshield, loosen four bolts (A) on support tube
bracket (B).
NOTE:
A D1X Series Draper Header is shown in the illustration. The
endshield on a D1XL Series Draper Header is similar.
$
%
Figure 3.16: Left Endshield Latch Assembly
3.
Loosen three bolts (A) on latch assembly (B).
4.
Adjust latch assembly (B) to achieve the desired gap
between the front end of the endshield and the header
frame. Refer to Table
for the recommended
endshield gap at various ambient temperatures.
5.
Tighten three bolts (A) on the latch assembly to 27 Nm
(20 lbf·ft).
$
%
$
$
$
Figure 3.17: Left Endshield Support Tube on D1X
Series Header
6.
Tighten four bolts (A) on support tube bracket (B) to 31 Nm
(23 lbf·ft).
NOTE:
A D1X Series Draper Header is shown in the illustration;
D1XL Series Draper Headers are similar.
7.
Close the endshield. For instructions, refer to
.
8.
Repeat Step
to Step
to adjust the
right endshield.
