215651
208
Revision B
Figure 5.178: Installing Plastic Finger
1.
Position the new finger on the rear of the tine tube. Engage
the lug at the bottom of the finger in the lower hole in the
tine tube.
2.
Lift the top flange gently and rotate the finger as shown
until the lug in the top of the finger engages the upper hole
in the tine tube.
$
Figure 5.179: Installing Plastic Finger
IMPORTANT:
Do
NOT
apply force to the finger prior to tightening the
mounting screw. Applying force without tightening the
mounting screw will break the finger or shear the
locating pins.
3.
Install screw (A) using a Torx
®
Plus 27 IP socket wrench and
torque to 8.5
–
9.0 Nm (75
–
80 lbf·in).
5.8.5
Tine Tube Bushings
Removing Bushings from Reels
Bushing are located where the reel tine connects to the reel disc.
WARNING
To prevent bodily injury from the fall of a raised reel, always engage the reel safety props before going under the
raised reel for any reason.
IMPORTANT:
Ensure the tine tube is supported at all times to prevent damage to the tube and other components.
1.
Lower the header fully.
2.
Raise the reel fully.
3.
Shut down the engine, and remove the key from the ignition.
4.
Engage the reel safety props. For instructions, refer to
Engaging Reel Safety Props, page 35
.
NOTE:
If replacing only the cam end bushing, proceed to Step
.
