© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-30 - [email protected] - www.malighting.com
1
Areas:
Here the physical width and height of the LED
matrix is determined.
This must not be conform to the whole size of the
LED Panels.
So e.g. only sub ranges of the general view of the LED
Panels can be set.
To set the dimensions of an area, select the area and
press Edit . The area is defined in n * m cm.
Outputs:
List of the outputs. Every pixel mapper
output can contain several fixtures. Network settings
can be defined seperately for every output.
Virtual Output:
The output of the Pixel Mapper can be
mapped as a virtual input of a layer.
In this case the render IP is suppressed.
Render IP:
Set which MA VPU shall render the output
by choosing its MA-Net2 IP.
Camera Idx:
Index of the camera used for this output.
Delay:
To each graphic output or Pixel Mapper output
a delay can be assigned.
The value accords to the refresh rate of the output
(not of the video clip).
For each output of the pixel mapper a delay from up
to 8/30 Seconds can be set (refresh rate for DMX
signal is 30/s).
Protocol:
Choose between Art-Net, sACN or MA-Net2
protocol. sACN is comparable to Art-Net but allows
the multicast option to reduce network traffic.
(American National Standard E1.31.2009)
Priority:
Set a priority for the output regarding to the
playback priorities of the grandMA2 desk. Default is
"low".
Example:
The physical dimensions of the source
picture must not confirm to the whole size of the
panels.
The LED panels can display, for example only a sub
range of the whole output.
In this example the area size is 1,25m x 1,0 m with 25
x 20 pixel.
There are only 16 panels used (5 x 5 LEDs).
The middle stripe is not equipped with LED panels
and is not used.
162 of 218
grandMA2 User Manual - Pixel Mapper – VPU - Pixel Mapper Graphical View
Version 3.4 – 2018-07-25
English