Lynx BRP REX2 49 RANGER 600HO E-TEC, Operator'S Manual

Page: 95 / 173

TUNE YOUR RIDE
fmo2014-003-009_a
1. Spacer on inside of ski leg
To change the ski stance, proceed as
follows on both sides:
1. Lift the front of vehicle.
2. Remove the ski bolt.
3. Place the spacer according to the
desired stance, see illustration.
fbg2013-009-002_b
PARTS LAYOUT - RH SIDE SHOWN
1. Ski leg
2. Ski runner
3. Ski stopper
4. Elastic Flanged Nut M10
5. Ski Axle
6. Models with adjustable stance
7. Bushings
8. Washer
9. Ski bolt (Hex. Cap Screw M10 x 100)
10. Flanged Nut M10
4. Install all the other parts and tighten
nut to the specified torque.
SKI BOLT TIGHTENING TORQUE
48 N•m ± 6 N•m (35 lbf•ft ± 4 lbf•ft)
NOTE: Make sure your vehicle does
not exceed the maximum width al-
lowed for trail riding. Check local regu-
lations.
Front Springs
Front spring preload has an effect on
front suspension firmness.
Front spring preload also has an effect
on the steering behavior.
ACTION RESULT
Firmer front
suspension
Higher front end
More precise
steering
Increasing preload
More bump
absorption
capability
Softer front
suspension
Lower front end
Lighter steering
Decreasing
preload
Less bump
absorption
capability
mmo2010-003-027_a
CAM TYPE - TYPICAL
1. Decrease preload
2. Increase preload
3. Spring preload adjustment cam
92
______________