Lynx BRP REX2 49 RANGER 600HO E-TEC, Operator'S Manual

Page: 101 / 173

MAINTENANCE SCHEDULE (E-TEC)
NOTE: The maintenance schedule does not exempt the pre-ride inspection.
WARNING
Failure to properly maintain the vehicle according to the maintenance
schedule and procedures can make it unsafe to operate.
EVERY 1 500 KM (1,000 MI)
Models with chaincase: Adjust drive chain
Models with chaincase: Check chaincase oil level
DRIVE
SYSTEM
Models with gearbox: Check oil level
EVERY 3 000 KM (2,000 MI) OR 1 YEAR
(WHICHEVER COMES FIRST)
Inspect heat shields
Inspect engine rubber mounts
Inspect exhaust system and check for leaks
Inspect cooling system cap, hoses and clamps and check for leaks
ENGINE
Adjust engine stopper
Visually inspect and clean drive pulley
Tighten drive pulley retaining screw to specified torque
Clean driven pulley
Adjust and align track
DRIVE
SYSTEM AND
BRAKE
Inspect brake hose, pads and disk
STEERING
SYSTEM
Inspect steering mechanism
FRAME
Retigthen rear member screws to frame to specified torque ( REX2
35 N•m (26 lbf•ft))
Inspect front suspension
Inspect rear suspension and stopper strap. PPS2 Suspension REX2
models: Replace stopper strap.
Lubricate front and rear suspension whenever the vehicle is used in wet
conditions (wet snow, rain, puddles)
Check ski leg bushing and bearing. Replace if needed.
SUSPENSION
All models with T/A shocks, oil change / service.
ELECTRICAL
SYSTEM
Replace spark plugs (ACE Models)
98
______________