Lynx BRP REX2 49 RANGER 600HO E-TEC, Operator'S Manual

Page: 127 / 173

STORAGE
mmr2009-004-002
NOTE: The storage mode does not
function in other modes (trip A, trip B
and hr trip).
4. Repeatedly depress the HI/LOW
beam switch rapidly, then, while
doing this , press and hold the SET
button until PUSH "S" appears on
the display.
NOTE: It is critical for this procedure
to depress the HI/LOW beam switch
repeatedly
before holding down the
SET button.
mmr2009-004-003
5. Release all buttons when gauge dis-
plays PUSH “S” appears.
6. Again, press and hold the SET (S)
button 2 - 3 seconds.
NOTE: The gauge will display OIL
when the storage procedure is initi-
ated.
7. When gauge displays OIL , release
button and wait for the lubrication
function to end.
mmr2009-004-004
Do not touch anything during engine lu-
brication cycle.
The engine lubrication function takes
approximately 1 minute. During this
time the engine RPM will increase
slightly to approximately 1600 RPM
and the oil pump will "oil flood" the en-
gine.
At the end of engine lubrication proce-
dure, the ECM will turn the engine off.
Remove tether cord.
NOTICE
Do not start the engine
during storage period.
124
______________