ODiSI 6
ODiSI 6
User’s Guide
Page 76
Table 7-1 List of remote-control commands
Command
Description
remote:stop
Stop Test
remote:set_filesave_on
Turn Test Data File saving on
remote:set_filesave_off
Turn Test Data File saving off
remote:getfilesave
Poll ODiSI Controller to get the file save state
remote.getfile
Download the last save test data file.
remote:add_channel=#
Add an identified sensor to the test configuration. The
hashtag/number sign should be replaced by an integer value
where 1 ≤ # ≤ the number of ODiSI channels
remote:remove_channel=#
Remove a channel/sensor from the test configuration. The
hashtag/number sign should be replaced by an integer value
where 1 ≤ # ≤ the number of ODiSI channels
ODiSI Controller Status
The following table describes the status messages that are sent back to the remote-control
application after a connection is established. The ODiSI controller will send status messages
back to the connected remote-control to indicate state changes and to give periodic updates
when the ODiSI controller application is in the identify/standby state.
Table 7-2 List of remote-control status messages
Status
Description
status:ready
Instrument is ready
status:armed
Intrument is armed
status:arming
Intrument is arming
status:start
Instrument started test
status:noinstrument
No instrument is connected to the controller
status:notready
Controller is in a state where it is not ready.
(Example: Incorrect configuration, no sensors connected)
