Lumenera Lt-C1610, User Manual

Page: 137 / 144

Teledyne Lumenera Lt Series Troubleshooting • 131
Important: DO NOT connect the camera to the USB 3 port before the two software installations
that follow.
•
Install the LuCam Software and Software Development kit first (file 1). This is required to
run the LtUpdater tool.
• Install the USB 3.0 Camera Firmware and Updater tool (file 2).
• Connect the Teledyne Lumenera camera to a USB 3 port.
•
Run the Teledyne Lumenera LtUpdater.exe tool from the desktop shortcut or from the typical
path "C:\Program Files\Teledyne Lumenera\LtUpdater\LtUpdater.exe".
The LtUpdater tool window will show that there is a camera connected in LuCam Mode. If all
fields are grayed out, then either the camera is not connected to the computer, is unpowered or
is already in USB3 Vision mode.
•
Click Select Packages and select the camera firmware zip file you have downloaded for your
camera model. The LtUpdater tool will automatically show the components within the zip file
that will update the camera.
•
Click Update and wait for confirmation of each updated component. The camera has been
programmed with the latest firmware version.
8.4.2 Using LtUpdater to Switch to USB3 Vision Mode
•
From the LtUpdater tool Camera Mode field, switch the camera from LuCam mode to
USB3 Vision mode.
•
Close the LtUpdater tool.
•
Cycle the camera power to reset the camera into USB3 Vision Mode.
• Start the Sapera LT CamExpert application to work with the Teledyne Lumenera camera as a
Sapera device.
8.5 Switching a Teledyne Lumenera camera from
USB3 Vision mode to LuCam mode
This procedure describes how to change mode with Sapera Lt CamExpert. You can also change it
with a USB3 Vision compliant third-party tool using the same features.
• Run CamExpert and select the Teledyne Lumenera Control category.
•
Change the Camera Boot Sequence value from USB3Vision to LuCam.