WaveLAN/EC-S User’s Guide
4-1
4
The Built-in Configurator
Introduction
4
If you wish to change the factory-set default configuration, the
easiest way to do so, is using the WaveMANAGER/EC program as
described in Chapter 3 ”Configuring WaveLAN/EC-S”.
As an alternative to the WaveMANAGER/EC program, the
WaveLAN/EC-S device also has a built-in configuration program,
that you can use when:
■
You do not have a computer running the Microsoft Windows 9x
and/or Windows NT v4.0 operating system (required to install
and run the WaveMANAGER/EC program).
■
The WaveLAN/EC-S device is connected to your computer via
a serial cable, using the RS-232 interface.
■
You wish to set specific RS-232 serial link parameters, which
can not be managed using WaveMANAGER/EC.
■
You wish to manage and configure the WaveLAN/EC-S device
from a remote computer.
You can start the built-in configuration program using a Telnet or
similar program as described on page 4-3, or by pressing the
Reset/Config button of the device (as described on page 4-8) to
display the built-in configuration program via a terminal emulation
program.
