LS tractor MT2 25S, Operator'S Manual, Page: 60 / 187

3 - 4
10
11
8
9

This indicator shall be ON when pressing brake pedal.
10 Parking brake indicator

This indicator shall be ON when turning the key
switch to ON position, and shall be OFF after
starting engine.

If this bulb becomes lit during operation, it
indicates that the charging system is not
operating normally. Contact your authorized
local dealer for checking the electrical charging
system.
9
Battery charging indicator

This gauge indicates the remaining amount of
fuel. If the needle indicates “ E ”, fill the fuel tank
immediately.

The gauge activates when the key switch is in
the ON position. It will register "empty" with the
key switch in the OFF position.
8
Fuel level gauge
12 PTO speed indicator

It determined by the engine speed indicated on
the tachometer. The tachometer reading of 2430
RPM indicates 540 RPM rear PTO speed.

If the tachometer registers higher than 2430
RPM for rear PTO operation, reduce the engine
speed when this dangerous over speed
conditions exists. For middle PTO operation, see
chapter 4-5-(2) in this manual.
12

The light indicates oil pressure only and goes out when sufficient oil pressure is present at the oil
sender.

This indicator will be turned on when turning the key switch to “ON” position, and it will be turned off
after starting engine.

If this indicator is turned on during operation, stop the engine immediately and contact your
authorized local dealer for checking the engine lubrication system.
11 Engine oil pressure indicator