LS tractor MT2 25S, Operator'S Manual, Page: 144 / 187

5 - 29
▶
When engine oil is warm, the
impurities can be drained
completely.
Notice
①
Drain Engine oil

Run the engine for a few minutes to warm oil.

Park the tractor on a level surface.

Remove both LH and RH drain plugs of the oil
pan and drain the oil completely.
5-7. Every 250 hour check
(1) Replacing Engine oil and Filter
Drain plug
Packing
Loosen
Tighten
③
Fill Engine oil

Tighten the drain plugs. (Tightening torque :
40
±
5 N.m) (29.5
±
5 lbs-ft)

Add new engine oil and check if the oil level is
between MIN and MAX marks on the oil gauge.

For oil specification, see chapter 5-3, “Lubricants
and Capacity” or the last page in this manual.

Check any leakage of the engine while running
the engine for several minutes at idle rpm.

Stop the engine. After about 5~10 minutes later,
check again if the oil level is between MIN and
MAX marks on the gauge. Install the oil gauge.
②
Replace Engine oil filter

Clean carefully around the filter.

Coat clean engine oil on the packing of new filter
and check the packing is placed well in the
groove.

Turn the oil filter counter-clockwise to remove it
with a filter wrench.

Turn the new filter clockwise to assemble it until
the packing makes contact with the mounting
surface. Tighten ¾ to 1 turn more after packing
contact.

If the metal is attached to the element of oil filter
to be disassembled, contact your authorized
dealer.
Oil filling port
Oil gauge
Engine oil filter