LS tractor MT2 25S, Operator'S Manual, Page: 135 / 187

5 - 20
(6) Air cleaner (Dry type)
①
Cleaning filter element

Remove the cover and pull out the primary filter
element straight out in the right figure.

When cleaning the element in the working field,
tap the element by hand to remove the dust.
▶
Do not tap the element on a
hard place when cleaning it.
▶
if the element is cracked,
change it with a new one.
Notice

If the dust is not removed by tapping, use the
compressed air {less than 500kPa (5bar, 72psi)}
from inside to outside as shown in the right
figure to remove the dust and dirt. And clean
inside the filter element with a clean damp cloth.
(5) Engine coolant

See chapter 5-10-(1), “ Replacement of Engine coolant ” in this manual. (See page 5-37)
(Pressurized air)
Cover
Primary filter
element
Evacuator
valve
②
Assembling filter element

Clean the inside of the air cleaner housing using a clean damp cloth.

Check if there is damage inside the filter element by using a light. If there is a tiny crack or small hole
in the filter element or the gasket is damaged, replace it with a new one.

Insert the filter element deeply into the filter housing.

Remove the dust of the evacuator valve and clean the inside of the cover.

Assemble the cover with the evacuator valve facing downwards.
▶
Do not assemble a wet filter element.
▶
Do not dry the wet filter element by using compressed air. It may cause damage to
the filter element.
▶
Do not start the engine or close the hood if the filter element is not assembled.
Notice