LS tractor MT2 25S, Operator'S Manual

Page: 137 / 187

5 - 22
(9) Tightening state of bolts and nuts of each part

Check if the bolts or nuts of each part are loosened. If necessary, tighten it again. Especially, check
the bolts and nuts of the tires before starting engine, if necessary, tighten them.
Tighten the wheel bolts and nuts to the
specified torque any time you remove the
wheel assembly from the machine or loosen
the wheel bolts or nuts.
Front Wheel Torque: M12x1.25P
950~1100 kgf.cm
(93~108 N.m, 69~80 lb.ft)
▶
Roll-over hazard!
Never operate the machine with a loose wheel rim or disc. Always tighten
nuts and/or bolts to the specified torque value and at the recommended
intervals.
Failure to comply could result in death or serious injury.
Warning
Rear Wheel Torque: M16x1.5P
1800~2000 kgf.cm
(177~196N.m, 130~145 lb.ft)
NOTICE: Check and tighten wheel bolts and
nuts to proper torque specifications after the
following hours of use:
• First 5 hours
• First 50 hours
• Every 300 hours
Wheel bolts and nuts
Wheel bolts and nuts