1.5 System pressure hazard
1.6 Function
The following must be observed during commissioning and
operation.
• All information within this manual and the information within the
referenced documents.
• All laws/ regulations that the operator must observe.
1.7 Assembly, maintenance,
malfunctions, shutdown,
disposal
• All relevant persons (e.g., operating personnel, supervisors) must
be informed of the activity prior to the start of work. Precautionary
operational measures/ work instructions must be observed.
• Ensure through suitable measures that moving/ detached parts
are immobilized during the work and that no body parts can be
pinched by unintended movements.
• Assemble the product only outside the operating range of moving
parts, at an adequate distance from sources of heat or cold.
• Prior to performing work, the product and the machine/ system in
which the product is or will be integrated must be switched off and
secured against unauthorized activation.
• All work on electrical components may be performed only with
voltage-insulated tools.
• Ensure proper grounding of the product.
• Drill required holes only on non-critical, non-load bearing parts.
• Other units of the machine must not be damaged or impaired in
their function by the installation of the product.
• No parts may be subjected to torsion, shear, or bending.
• Use suitable lifting gear when working with heavy parts.
• Avoid mixing up/ incorrect assembling of disassembled parts.
Label parts.
1.8 Intended use
The product is designed for the lubrication of moving conveyor
chains. Lubricant is squirted without air straight on lubrication
points. Product may only be used following the specifications, techni-
cal data and limits stated in this manual. Other use or use beyond
this purpose is considered unintended.
1.9 Foreseeable misuse
A usage of the product differing from the aforementioned conditions
and stated purpose is strictly prohibited. Particularly prohibited are:
• use in an explosive atmosphere (according to guideline ATEX
2014/34/EU)
• use without integrated pressure-limiting valve
• in continuous operation
• to supply, transport, or store hazardous substances and mixtures
in accordance with annex I part 2-5 of the CLP regulation (EC
1272/2008)
• to feed, forward, or store gases, liquefied gases, pressurized gases
in solution and fluids with a vapor pressure exceeding normal
atmospheric pressure (1013 mbar) by more than 0,5 bar at their
maximum permissible temperature.
• for the supply, transport , stockpiling of oils and greases containing
glycol or polyglycol. These may damage the reservoir.
1.10 Applicable documents
In addition to this manual, the following documents must be obser-
ved by the respective target group:
• Operational instructions and approval rules
• Safety data sheet (MSDS) of the lubricant used
• Instructions from suppliers of purchased parts, project planning
documents and other relevant documents.
The operator must supplement these documents with applicable
regulations for the country of use. This documentation must be
included, if the product is sold or transferred.
WARNING
System pressure
The product is pressurized during operation. The product
must therefore be depressurized before starting assembly,
maintenance, or repair work
7
Summary of Contents for SKF CLK
Page 37: ...37 ...
