7.2.3.5 Fine adjustment – Nozzle position
The user can adjust the position of the nozzles relative to the lubrica-
tion points, without mechanical intervention. To do so, the user
increases or decreases the lubrication signal advance in order to
refine the accuracy of the projection impact.
Fine adjustment, menu 6
Screen
Description
• Go to menu 6
Fine adjustment
with
• Enter the menu by pressing for 5 seconds
• Increase or decrease advance of the impact location on chain with
• Confirm and go back to menu 6
Fine adjustment
by pressing
4
+ 0 0 0 0 m s
O F F S E T
4
> + 0 0 0 0 m s
<
O F F S E T
7.2.3.4 Pump control
Lubrication impulse triggering when the lubrication point is detected.
Lubrication impulse can be triggered straight – DIRECT – when
control unit receives the signal from proximity switch (factory set-
ting). This solution suits to chain with constant speed or with fre-
quent stops. With this mode it may be necessary to adjust mechani-
cally the proximity switch or nozzle(s) position to balance the system
response time.
The lubrication impulse triggering can be adjusted automatically
– ADAPTIVE – after reception of the proximity switch signal. Recep-
tion times of previous proximity switch signals are taken into
account. This solution suits to chains with variable speed or with very
few stops.
Pump control, menu 5
Screen
Description
• Go to menu 5
Pump control
with
• Enter the menu by pressing for 5 seconds
• Select control mode with
• Confirm and go back to menu 5
Pump control
by pressing
5
A D A P T I V E
P U M P C O N T R O L
5
> A D A P T I V E <
P U M P C O N T R O L
NOTE
This setting is only possible when in the previous menu PUMP
CONTRAL the parameter ADAPTIVE has been selected.
In the contrary, the menu is locked and can not be modified.
27
Summary of Contents for SKF CLK
Page 37: ...37 ...
