Lincoln SKF CLK, Installation And Operation Manual

Page: 25 / 38

determined by the number of axes of the chain († § 7.2.3.2) , fol-
lowed by the pause phase. The minimum cycle time is 0 h 01 min,
and the maximum cycle time is 999 h 59. The default set value is 0 h
01 min.
Lubrication, menu 2
Screen Description
• Go to menu 2 Lubrication with
• Enter the menu by pressing for 5 seconds
• Select the lubrication mode with
– Continuous*
– Semi-automatic*
– Cyclic
If you select cyclic lubrication, it is necessary to set the cycle time with the same keys. The
minimum cycle time is 0 h 01 min, and the maximum cycle time is 999 h 59.
*) To access the Continuous and Semi-automatic parameters, you have to lower the time to 0
h 01 min
• Confirm and go back to menu 2 Lubrication by pressing
2
0 0 2 h 3 0 m i n
L U B R I C A T I O N
2
> C O N T I N U O U S <
L U B R I F I C A T I O N
2
> S E M I - A U T O <
L U B R I C A T I O N
2
> 0 0 2 h 3 0 m i n <
L U B R I C A T I O N
Lubrication cycle
A lubrication cycle consists of a lubrication phase, during which
lubrication points are lubricated, followed by a pause phase. There
are two parameters to be set: the duration of the lubrication cycle in
time and the number of chain roller to be lubricated during the lubri-
cation phase. The length of the pause phase depends on the total
number of lubrication points and the duration of the lubrication
cycle.
Semi automatic lubrication
The user manually triggers the lubrication phase. This phase corres-
ponds to the number of lubrication points set by the user. Once the
last point has been lubricated, the lubrication phase is done and the
system stops. The user can trigger another lubrication phase whene-
ver necessary.
Continuous lubrication
All lubrication points are continuously lubricated as long as the chain
is running and the lubrication system is powered.
6 Fine adjustment: adjustment of the projection position relative to
the chain
7 Draining: lubrication circuit draining
8 Status of inputs and outputs
9 Languages: selection of the control unit interface language
To move from one menu to another, press the navigation buttons.
7.2.3 Parameters
The control unit allows you to adjust various parameters.
7.2.3.1 Lubrication
The lubrication parameter allows to adjust the lubrication system
mode: cyclic, semi-automatic or continuous. In case of cyclic lubrica-
tion, you should set a time corresponding to the time between two
lubrication cycle start-ups. The cycle includes the lubrication phase,
25