39
ENGLISH
Error codes
Problem
Possible Cause
Solutions
The display shows:
Drawer is not closed properly
•
Close the drawer and press START/
PAUSE button to start the cycle.
•
If the drawer is closed and the drawer
lock error message is displayed, call for
service
The display shows:
Lid is not closed properly
•
Open the drawer and make sure the
latch area is free of clothing or other
obstructions.
•
Close the lid, shut the drawer, and press
START/PAUSE to start the cycle.
•
If the lid is closed and the lid error
message is displayed, call for service
Washer fills with water
slowly or not at all, or
the display shows:
Water supply faucets are not fully
open.
•
Make sure that the water faucets are fully
open.
Water line hoses are kinked,
pinched, or crushed.
•
Make sure that the hoses are not kinked
or pinched. Be careful when moving the
washer during cleaning and maintenance.
Water inlet filters are clogged.
•
Clean the inlet filters. See Maintenance in
the Care and Cleaning section.
Water supply pressure to faucet or
house is too low.
•
Check another faucet in the house to
make sure that household water pressure
is adequate and flow is not restricted.
Disconnect the inlet hose from the washer
and run a few gallons of water through
the hose to flush the water supply lines. If
flow is too low, contact a plumber to have
the water lines repaired.
Water supply connected with
leaklimiting hoses.ga.
•
Hoses designed to limit leaks can trip
falsely and prevent the washer from
filling. The use of leak limiting hoses is
not recommended.
Washer will not turn on
Power cord is not properly
plugged in.
•
Make sure that the plug is plugged
securely into a grounded, 2-prong. 220-
VAC, 50-Hz. outlet.
House fuse is blown, circuit
breaker has tripped, or power
outage has occurred.
•
Reset circuit breaker or replace fuse. Do
not increase fuse capacity. If the problem
is a circuit overload, have it corrected by
a qualified electrician.
MFL69482502_EN.indd 39
16. 4. 5. 오전 9:16
